The first step in falling a tree is to determine the direction of the fall. A falling tree may end up in your home or den. Make sure you create a safe passageway for the tree to fall and yourself. If you do choose to use fire, be aware that it can destabilize the tree. If the wind is strong, you may have to run uphill to avoid a dangerous situation.
Once you’ve decided which direction to fall the tree, you can begin cutting. Start with an initial 45-degree chop and then make a second cut a few inches above the first one. When the second cut is complete, the offset will act as a quasi hinge for the falling tree. After the second cut, you’ll have the stem and the crown of the tree, which will serve as your shelter.
Once you’ve selected the direction of fall, the next step is to balance yourself on the axe’s head. While the axe will fall the tree, make sure to balance yourself so that you don’t strain yourself. Your stance should be slightly offsetting to the tree so that your body is parallel to the tree. Once you’ve done this, you’re ready to proceed with the chopping.
To fall into a tree with an axe, you need to make an initial 45-degree cut on the face of the tree. This will create a notch. Continue this cut with a 45-degree angle chop until it’s about a third of the way through the tree. You should then make another cut on the opposite side of the tree, more than halfway through. The offset will act as a quasi hinge when the tree falls.
Read also: How Much Does a Christmas Tree Weigh?
Things to Consider Before Felling a Tree with an Axe
When felling a tree, it’s essential to have a clear path. You can’t fall a tree on the ground. You need to have a clear path to walk. If the trunk is blocked by branches, you’ll have to work around them. This is a dangerous, unpractical, and unsafe technique. When felling a large tree, it’s essential to follow the right axe stance.
The next step in how to fell a tree with an ax is to make sure the ax is in the right position for the cut. To do this, hold the ax handle vertically and close one eye. Once you’re positioned, you can see where the axe will fall from and how much the remaining pieces will fall. If the axe hits the leading leg, the leg may be broken or even broken.
Before you start making the cut, remember to wear safety gear. A hard hat is recommended as your head can be seriously damaged by an axe. While safety is your first priority, you should consider the angle of the cuts you’ll make. Using a saw will make your cut much worse. (https://whitejasmine.com/) A saw can cause injury to your face. With an ax, you’ll have to take the time to find the right stance to avoid cutting your face.
Regardless of whether you’re working on a flat surface or on a slope, you’ll want to be aware of your stance when cutting a tree with an axe. In general, you’ll want to make a front and a back cut. The front cut will be easier to make with an axe, but a saw can be more difficult. In either case, the main goal is to fall the tree with an ax.
To fall a tree, you’ll need to make a 45 degree cut on both sides. After cutting the front cut, you’ll need to make a back cut two inches above it. The back cuts create a hinge between the two sides of the tree. When a tree falls, it will fall in the direction of the face cut. So, you’ll want to be aware of the angles when falling a tree.