Before you can cut big chunks of wood, you must learn how to cut large tree trunk slices. To achieve this, you must first find the right place to support the log on two ends, as well as one end, so that you can safely saw through the trunk. You must also be aware of the importance of over-bucking and marking the log before you start cutting. Here are a few steps you need to take to make your task a success.
Quick Steps For Cutting Large Tree Log
To begin cutting your tree log, you will need to place the tree on a higher platform and mark the knots that you want to remove. Another way to ensure a straight cut is to make a jig, a piece of wood that has a flat surface. Using a jig will ensure that your slices are the same thickness, and it will also prevent the saw from getting stuck.
If you are planning to chainsaw the tree log, you must wear safety gear. You should wear a face mask and a chainsaw helmet. Also, you need to prop the end of the tree up so that you can easily cut it. A good method for doing this is by using scrap wood underneath. A chainsaw will need at least 6 inches of clearance to be able to cut the wood cleanly. Once you’ve secured the stump with the scrap wood, the next step is to prepare the cutting area.
Once you’ve set up your tree log on a raised platform, you can begin cutting. Before you begin cutting the tree log, mark the knots and trees. This will help you avoid any mistakes that may occur. It’s important to have the right tools so that your cuts will be straight and even. You should also have enough space to move around the tree without damaging it. If you’re cutting a very tall trunk, you’ll need to mark it so that the slices will be evenly-spaced.
Once you’ve chosen the best spot, you should prepare your wood. You can use it to make table decorations, table runners, or even trivets. If you are cutting large tree trunk slices for tables, you should be sure to mark the points with a pencil or a ruler. Once you’ve marked the points on the wood, you can then move on to cutting the tree. You should ensure that you don’t chop the trunk too much or risk causing damage.
Before you begin cutting the tree log, you should raise the platform a few inches higher. Then, mark the knots so that you can cut the wood at an even angle. You can use a jig to ensure that all the wood slices have the same thickness. Afterward, you can make the tabletop pieces out of wood. If you have a chainsaw, you can set the angle of the cut to ensure that it’s parallel to the ground.
Read Also: How Much Garland For a 6 Foot Tree?
Before cutting the tree log, you should prepare the platform. You must identify the knots and measure its diameter. After that, you must cut two x 4s to the same size. The 2 x 4s must be at least four inches longer than the initial measurement to allow for the extra space to be placed underneath the tree. Alternatively, you can buy a tabletop made from wood slices. All of these are possible to make with a chainsaw.
Conclusion
While you may not be sure of how to cut large tree trunk slices, you should take the proper safety precautions. Always wear a face mask and safety glasses. If you are chainsawing a tree, it is important to prop the end up at least 6 inches off the ground to avoid slipping. If you don’t have a tabletop to prop the slice up, use scrap wood. You should make sure the wood is level before you use the saw.
When you’re ready to cut the tree log, you must set up your chainsaw horse and mark the points of the wood with a tape measure. Once you’ve measured the diameter, you must cut two x 4s to the same length. It’s important to leave extra room between the two x 4s to slide over the tree trunk. Ensure that you do not make the tree slices too thick or you might end up with a large mess.